OUTER PLASTIC JACKET REPAIR

TM 11-5995-208-24&P-1

CAP REPLACEMENT AND REPAIR (CONT)

3. Position screw lug (4) with retaining wire (5) on back of cap (2).

4. Install screw (6).

NOTE

The work should be allowed to cure at room temperature for 24 hours.

OUTER PLASTIC JACKET REPAIR

TOOLS: Electronic Equipment Tool Kit TK-101/G

MATERIALS/PARTS: Flouriglass fabric tape (l-inch-wide)

Outer jacket material

PERSONNEL REQUIRED: Two technicians

GENERAL

CAUTION

Repair of outer plastic jacket should be made only if cable shield is damaged.

This procedure is for repair of holes and openings in outer plastic jacket. It is not intended that repairs

be made on areas more than 1 inch in length or over one-half the diameter of cable.

2-9