 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 11-5920-252-24
5.
Remove and label the connectors JI, J2 and J3.
6.
Before installation, remove the three connector retaining nuts from the J connectors of the arrester.
7.
From the inside of the SIGNAL ENTRANCE panel, place the arrester J1, J2 and J3 connectors through
the SIGNAL ENTRANCE panel holes. Be certain that the washer-shaped metal fiber RFI gaskets are
in place on the three arrester J connectors.
NOTE
The arrester connectors and the panel holes will be flattened on the top. If they do not match, do not
force into place or install the arrester upside down.
8.
Install and tighten the connector retaining nuts on connectors J1, J2 and J3.
NOTE:
CONNECTOR RETAINING NUTS FURNISHED
WITH ARRESTER.
3-7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals