BACKPLANE CONNECTOR PANEL REMOVAL AND INSTALLATION

T.O. 31W2-2GSC24-2

TM 11-5805-688-14-1

NAVELEX 0967-LP-545-3010

Figure 6-23. DELETED.

Figure 6-24. DELETED.

On right side of chassis frame, remove four screws

securing card file assembly to chassis.

5. Disconnect power cables from terminals

E1, E2, E3, and E4 on backplane panel.

When performing step 7,

insure that

capacitor assembly on rear of backplane

connector panel is not subjected to any

pressure that could cause damage to the

assembly on backplane wiring.

When performing steps 6 and 7, use care to

prevent damage or wire breakage of fine

7. Slide card file assembly forward in chassis

wiring on rear of card file.

and then lift from chassis.

6. Remove four screws securing capacitor

assembly on bottom rear of backplane connector panel

to chassis.

Change 2 6-61/(6-62 blank)