CHAPTER 2 INSTALLATION - TM-11-5805-688-14-10034

T.O. 31W2-2GSC24-2

TM 11-5805-688-14-1

NAVELEX 0967-LP-545-3010

CHAPTER 2

INSTALLATION

SECTION I

INSTALLATION LOGISTICS

2-1. GENERAL..

2-2. This section contains general instructions for

unpacking and storing the multiplexer set prior to

Use care when lifting multiplexer

installation as prescribed in section II.

set from container to prevent

2-3. UNLOADING AND UNPACKING.

damage to protruding controls,

indicators, and receptacles on the

unit.

2. Remove multiplexer set from shipping container.

The multiplexer set weighs 140

Remove moisture resistant barrier material from

pounds. Use a mechanical lifting

multiplexer set.

device whenever possible.

3. Inspect exterior surfaces of multiplexer set for

prevent injury to personnel, it is

shipping damage, missing or damaged controls and

recommended that a minimum of

indicators, and evidence of water damage.

four men be used when a

multiplexer set is to be lifted

4. Check received equipment against shipping

manually.

documents and/or packing slip.

2-4. During the unpacking procedures, the multiplexer

5. When equipment is incomplete or damaged, fill

set should be positioned on a firm, level surface in an

out and forward appropriate forms in accordance with

area that is protected from the elements. No special or

prescribed directives.

unique procedures are required for unpacking the

multiplexer set.

2-5. STORAGE HOUSING REQUIREMENTS.

NOTE

2-6. The multiplexer set should be housed to protect it

from inclement weather. The unit should be stored

Use care when opening the shipping

within an ambient temperature range of -80 to +160F (-

container to prevent unnecessary

62 to +71C). The multiplexer set in a nonoperating

damage to the container so that it may

condition can be stored at altitudes from sea level to

be stored and reused for repacking a

50,000 feet (3.44 inches Hg). The multiplexer set can be

multiplexer set for reshipment.

stored on a flat surface capable of supporting 50 pounds

per square foot. The accessories listed in paragraph 2-8

1. Open the shipping container and carefully

should be inventoried

remove loose padding and fill material.

2-1