 |
|||
|
|
|||
|
Page Title:
MAG TAPE CONTROLLER PC CARD COMPONENT PERFORMANCE TEST |
|
||
| ||||||||||
|
|
 T.O. 31S5-4-308-1
TM 11-5805-663-14-13
NAVELEX 0967-464-0010
j . The TTY shall print out:
S4, as follows: S1 and S2 to up position,
S3 and S4 to down position.
TTY ADD =
Mount and thread ATP tape on Mag
Tape Unit 1 (A1A1).
k. Type in either:
d. On Mag Tape Unit, perform the
F8OO(C/R)
following:
1. The TTY shall print out:
1. Press LOAD switch.
BTA = (YES = l, NO = O)
2. When tape movement stops press
m. On Program Maintenance Panel:
LOAD switch again.
1. Enter hexidecimal 100 in address
3. When LOAD lamp is lighted, press
line.
ON LINE switch.
2. Enter hexidecimal 4004 in data
4. If LOAD lamp is not lighted after
line.
the tape reel has made five or more revolu-
tions, press REWIND switch; then, when
n. Type in:
LOAD lamp lights, press ON LINE switch.
Press reset and load switch.
0(C/R)
e.
o. The TTY shall print out:
f. When tape motion stops repeat step
e twelve more times, to reach the thirteenth
program (tape motion must come to a stop
TST 01
after each load).
p. When TEST 01 starts, immediately
g . Press run switch.
press write switch in address line.
q . Turn off TTY power switch.
h. The TTY shall print out:
r. Go to step 7 of table 6-32.
MAG TAPE (BTA) TP
SUE
R/R OR C (1 or 0) =
COMPONENT PERFORMANCE TEST. The
component performance test for the Mag
i . Type in:
Tape Controller PC card is used to isolate
malfunctions to an IC or group of IC's. To
1(C/R)
accomplish the Mag Tape Controller PC card
component performance test perform the pro-
j . The TTY shall print out:
cedure in table 6-33.
ADDR =
ATP test tape as follows:
k. Type in:
a . Open front panel (Program Mainte-
F8C0(C/R)
nance Panel).
1. The TTY shall print out:
b. On Processor Auto-Load PC card
A1A3A9, set the four red toggle switches,
LVL =
designated from top to bottom as S1 through
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals