 |
|||
|
|
|||
|
Page Title:
CPB PC CARD COMPONENT PERFORMANCE TEST |
|
||
| ||||||||||
|
|
 T.O. 31S5-4-308-l
T M 11-5805-663-14-13
NAVELEX 0967-464-0010
a. Open Program Maintenance Panel.
a. Open Program Maintenance Panel.
b. On Processor Auto-Load PC card
b. On Processor Auto-Load PC card
A1A3A9, set the four red toggle switches,
A1A3A9, set the four red toggle switches,
designated from top to bottom as Sl through
designated from top to bottom as S1 through
S4, as follows: Sl and S2 to up position,
S4, as follows: Sl and S2 to up position,
S3 and S4 to down position.
S3 and S4 to down position.
Mount and thread ATP tape on Mag
c . Mount and thread ATP tape on Mag
Tape Unit 1 (A1A1).
Tape Unit 1 (A1A1).
d. On Mag Tape Unit, perform the fol-
d. On Mag Tape Unit, perform the fol-
lowing:
lowing:
1. Press LOAD switch.
1. Press LOAD switch.
2. When tape movement stops press
2. When tape movement stops press
LOAD switch again.
LOAD switch again.
3. When LOAD lamp is lighted, press
3. When LOAD Lamp is lighted, press
ON LINE switch.
ON LINE switch.
4. If LOAD lamp is not lighted after
4. If LOAD lamp is not lighted after
the tape reel has made five or more revolu-
the tape reel has made five or more revolu-
tions, press REWIND switch; then, when
tions, press REWIND switch; then, when
LOAD lamp lights, press ON LINE switch.
LOAD lamp lights, press ON LINE switch.
e. Press reset and load switches.
e . Press reset and load switches.
f. When tape motion stops, repeat step
f. When tape motion stops, repeat step
e four more times to reach the fifth program
e four more times to reach the fifth program
(GIN 4). Tape motion must stop after each
(GIN 4). Tape motion must stop after each
load.
load.
g. Press run, after the fifth load.
g. Press run switch after the fifth load.
NOTE
NOTE
A loop count will appear in bits 4
A loop count will appear in bits 4 to
to 14 and bit 2 will light to indicate
14 and bit 2 will light to indicate
GIN 4 is operating.
GIN 4 is operating.
h. Go to step 9 of table 6-22.
h. Go to step 9 of table 6-23.
FORMANCE TEST. The component perform-
CARD COMPONENT PERFORMANCE TEST.
ance test for the CPB PC card is used to
The component performance test for the Core
isolate malfunctions to an IC or group of
Memory Controller PC card is used to iso-
IC'S. TO accomplish the CPB PC card com-
late malfunctions to an IC or group of IC's.
ponent performance test perform the proce-
To accomplish the Core Memory Controller
dure in table 6-23.
PC card component performance test perform
the procedure in table 6-24.
6-45. After step 7 of table 6-23, load the
ATP tape as follows:
ATP tape as follows:
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals