 |
|||
|
|
|||
|
Page Title:
BUS CONTROLLER PC CARD COMPONENT PERFORMANCE TEST |
|
||
| ||||||||||
|
|
 T.O. 31S5-4-308-l
TM 11-5805-663-14-13
NAVELEX 0967-464-0010
b. On Processor Auto-Load PC card
a . Open Program Maintenance Panel.
A1A3A9, set the four red toggle switches,
designated from top to bottom as Sl through
b. On Processor Auto-Load PC card
S4, as follows: Sl and S2 to up position,
A1A3A9, set the four red toggle switches,
S3 and S4 to down position.
designated from top to bottom as S1 through
S4, as follows: S1 and S2 to up position,
Mount and thread ATP tape on Mag
S3 and S4 to down position.
Tape Unit 1 (AlAl).
Mount and thread program tape on
d. On Mag Tape Unit, perform the
Mag `Tape Unit 1 (AlAl).
following:
d. On Mag Tape Unit, perform the
1. Press LOAD switch.
following:
2. When tape movement stops press
1. Press LOAD switch.
LOAD switch again.
2. When tape movement stops
3. When LOAD lamp is lighted, press
LOAD switch again.
ON LINE switch.
3. When LOAD lamp is lighted, press
4 . If LOAD lamp is not lighted after
ON LINE switch.
the tape reel has made five or more revolu-
tions, press REWIND switch; then, when
4. If LOAD lamp is not lighted after
LOAD lamp lights, press ON LINE switch.
the tape reel has made five or more revol-
utions, press REWIND switch; then, when
Press reset and load switches.
e.
LOAD lamp lights, press ON LINE switch.
f. When tape motion stops, repeat step
e . Press reset and load switches on the
e four more times to reach the fifth program
Program Maintenance Panel
(GIN 4). Tape motion must stop after each
load.
f. When tape motion halts press run
switch.
Press run switch after the fifth load.
g . Proceed to step 7 of table 6-20.
NOTE
h. Program tape must be loading while
readings are being taken. If necessary,
rewind and reload program tape, as required
to continue test.
h. Go to step 9 of table 6-21.
NENT PERFORMANCE TEST. The component
performance test for the Bus Controller PC
card is used to isolate malfunctions to an XC
FORMANCE TEST. The component performance
or group of IC'S. To accomplish the Bus
test for the CPA PC card is employed to iso-
Controller PC card component performance
late malfunctions to an IC or group of IC's.
test perform the procedure in table 6-21.
To accomplish the CPA PC card component
performance test perform the procedure in
6-41. After step 7 of table 6-21, load the
ATP tape as follows:
6-43. After step 7 of table 6-22, load the
a . Open Program Maintenance Panel.
ATP tape as follows:
6-58
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals