REPLACEMENT - TM-11-3895-209-140043

TM 11-3895-209-14

4-2. REMOVAL AND REPLACEMENT OF CHOKE CONTROL - Continued

G Remove bolt (18), lock washer (19), and choke control bracket (20).

H Remove nut (11), lock washer (12), and choke and throttle bracket (13).

I Remove bolt (5), and choke and throttle bracket (6) from the engine cowling.

REPLACEMENT

A Replace bolt (5), and choke and throttle bracket (6).

B Replace nut (11 ), lock washer (12), and choke and throttle bracket (13).

C Replace bolt (18), lock washer (19), and choke control bracket (20).

NOTE

Installation of the three brackets ((6),(13), and (20)) on the engine is required only if the

brackets have been removed for repair or replacement of the engine.

D Pull CHOKE control rod (23) through the hole in control panel.

E Replace nut (21 ) and lock washer (22) on shaft of the CHOKE control rod (23).

F Hook CHOKE control rod (23) wire from the choke lever on carburetor.

G Replace nut (15), lock washer (16), screw (14), and choke cable clamp (17).

H Replace screw (7), nut (8), lock washer (9), and choke and throttle clamp (10).

Replace screw (1), nut (2), lock washer (3), and control cable clamp (4).

4-13. REMOVAL AND REPLACEMTN OF THROLTTLE CONTROL

REMOVAL

A Loosen setscrew (8) in the

throttle lever.

B Remove nut (2), lock washer

(3), screw (1), and remove

clamp (12).

C Remove nut (5), lock washer

(6), screw (4), and remove

the choke and throttle clamp

(7).

4-11