Figure 3-1. Folding Procedure

TO 14P3-5-61

TM 10-8475-202-13

STEP NO. 1

ALL THE PARTS OF THE COVERALL, HOOD, AND GLOVES SHALL BE COVERED WITH A MINIMUM

AMOUNT OF ZINC STEARATE OR TALC TO PREVENT ADHERING OF THE AD. JACENT CLOTH

SURFACES, TAPES, AND CEMENTED AREAS DURING NORMAL STORAGE AND

TRANSPORTATION CONDITIONS. CARE SHALL BE EXERCISED SO THAT NO ZINC STEARATE

OR TALC SHALL CONTAMINATE THE COVERALL ENTRANCE SLIDE FASTENER. THE HOOD

SHALL BE COMPLETELY EVACUATED OF AIR AND THE ORAL INFLATION VALVE SHALL BE

LOCKED IN THE CLOSED POSITION BY THE KNURLED RING, ONE END OF THE TIE CORD SHALL

BE SECURELY ATTACHED TO THE SEWN EYELET IN THE HOOD. THE OTHER END OF THE TIE

CORD SHALL BE SECURELY ATTACHED TO THE SEWN EYELET IN THE HEM OF THE RIGHT-

HAND COVERALL POCKET, THE HOOD SHALL BE FOLDED IN HALF AND THEN ROLLED. THE

ORAL INFLATION TUBE AND VALVE SHALL BE ON THE INNER SIDE OF THE ROLL AND THE

HOOD SHALL BE INSERTED INTO THE RIGHT-HAND POCKET. THE ADJUSTMENT STRAP AND

TIE CORD SHALL BE SNAPPED TO THE GLOVES. THE FREE ENDS OF THE TIE CORDS

ATTACHED TO THE GLOVES SHALL BE SECURELY ATTACHED TO THE PROPER SEWN EYELET

IN THE HEM OF THE POCKETS. THE GLOVES SHALL BE FOLDED IN HALF AND PLACED IN THEIR

RESPECTIVE POCKETS AND THE POCKET FLAPS SHALL BE SNAPPED CLOSED.

SLIDE

FASTENER SHALL BE CLOSED TO A POINT APPROXIMATELY 3 TO 4 INCHES FROM THE SEAL

BLOCK.

PLACE SLEEVES ACROSS

FOLD THE RIGHT SIDE OF

BACK AS SHOWN IN

THE COVERALL OVER THE

STEP NO. 3

LEFT AS SHOWN IN STEP

NO. 4

Figure 3-1. Folding Procedure

3-2 Change 13