Mechanical Inspection - SB-740-91-010351

SB 740-91-01

(3)

All connectors and receptacles are identified by correct

and legible designations.

(4)

Verify all covers are tight and no screws or bolts are

stripped.

(5)

Verify that the ground strap is securely fastened to the

PDU housing.

(6)

Verify pressure relief valves is spring loaded to the

closed position and it does not appear damaged.

(7)

Verify the paint finish is uniform over the entire housing.

(8)

Verify bracket angle is bent at right angles, and is not

bent in any other angle.

(9)

Verify pipe plug is in tight and has sealant applied in

the threads.

(10) At the rear of the PDU there shall be three (3) decals.

(11) Verify handle is tight and the paint is not scratched or

scraped off.

(b) Mechanical Inspection

(1)

Verify all screws and fasteners are tight.

(2)

Verify all knobs and switches are secured on their

control shafts.

(3)

Remove pilot light lens, verify that light bulbs are in

the sockets.

(4)

At the rear of the PDU, connectors J1 and J7 shall have

metal covers secured by a beaded chain. Be sure that

the covers are tight and fastened to the connector

(5)

Open battery cover and verify there shall be no battery

in the compartment. If there is, remove it.

Change 1 B-130.28